CableHorn™
|
|
In many applications the use of the CableHorn™ system can eliminate the need for cable trays to be installed. Cables may be added or removed after the CableHorn™ is installed. When used in conjunction with the PulsaLift™ pole system, CableHorns™ may be installed from the ground without the need for ladders or scissor lifts. |
|
SPECIFICATIONS
| Capacity |
Double CableHorn™; 16 cables, 3 x
1.5mm2 maximum
Single CableHorn™: 8 cables, 3 x
1.5mm2 maximum.
|
| Spacing Recommendations |
Between 0.60m and 1.50m |
| Raw Material |
High impact modified Pa66 Halogen free polypropylene.
|
| Fire Resistance Properties |
Incandescent wire test (IEC 695): 650 °C UL94 HB (ISO 1210): 100 mm/min |
| Low Temperature Tests |
No breakage at 0 °C |
| Quality Certificate |
TUV certificate ISO 9001 |
| Dimensions |
Single CableHorn™: Length 137mm.
Double CableHorn™: Length 228mm |
| Fixing Base |
Double CableHorn™: 19.5 x 24.3mm
Single CableHorn™: 19.5 x 38.5mm. |
|
|
|
FEATURES & BENEFITS
|
Designed for use with electrical, data and communication cables.
Replaces the need for cable tray and catinary wire.
Clips directly onto the CableMaster™ Pin Guide allowing one-handed operation.
Can be used with the PulsaLift™ Pole to fix from the ground.
Add or remove cables as required.
In-built energy absorber for perfect embedment.
Large fixing base for better stability.
Flexibility in installation-vertical, horizontal, overhead.
Optional plug and screw installation.
|
|
|
INSTALLATION GUIDE
|
1. Simply clip the CableHorn™ to the tool pin
2. Press against the substrate (5kg to actuate the tool) press the trigger to fix.
3. Install the cable simply by lifting the edge of the CableHorn™ .
|
|
|
TECHNICAL DATA & DOCUMENTS
|
*NOTE: Test concluded when clip pulled over pin head or pin failed. Job-site testing may be required to determine actual achievable job-site values.
Results have been achieved with a CableMaster™ tool set at minimum overdrive setting. Accessories failing to fix correctly should be removed and a new fixing set away from any spalled concrete. Tension loads provided are for static load situations only. Values represent a minimum factor of safety of 3:1 on the lowest test results achieved. Minimum edge distance 75mm, minimum spacing between fixings 50mm. Tension loads are per fixing, however a minimum of 3 fixings per fastening unit should be used.
|
PRODUCT INFORMATION
|
TECHNICAL INFORMATION
|
|
|
|
|
